Forums > General Discussion > How to operate automatic desktop labeling machine?
| How to operate automatic desktop labeling machine? | |
|---|---|
| Posted: 11 Jul 2022 04:01 UTC | Post #1 |
| beilt Deck & Engine |
Registered Total Posts: 7 |
| 1. The installation of the label must be in place. When the automatic desktop labeling machine wraps the label, try to wrap it as neatly as possible. It is easier to break the label if it is crooked. After the label is installed, fix the position with the limit ring. 2. Adjust the conveying guide bar according to the width of the product to be labelled, and leave a gap of 1mm between the two guide bars of the automatic desktop labeling machine and the product. However, general paper card products use unilateral guide bars, so it is only necessary to adjust the two ends of the conveying guide bars to be relatively flat. 3. According to the height (thickness) of the product, adjust the position of the Z-axis direction of the label head of the automatic flat labeling machine, so that the peeled label can be attached to the surface of the product in time when the label roll of the automatic flat labeling machine is pulled. Generally, the header of cardboard is adjusted to the height where the peeling plate basically touches the surface of the product. For thicker products, such as boxes and books, the header should be adjusted to a height of 1-2mm between the peeling plate and the surface of the product. After the adjustment is completed, lock the Z-axis direction. 4. Adjust the measuring electric eye of the automatic desktop labeling machine. Tear off a label that is about to enter the area of the target measuring sensor, long press the button on the target measuring sensor of the automatic desktop labeling machine to enter the setting state, and manually pull the label roll in the manual interface of the touch screen, so that the backing paper of the label is torn off. After the automatic desktop labeling machine has completely measured the sensor area of the target sensor, press the button on the target sensor again to confirm the completion of the setting. If the optical fiber sensor is used for the measurement of the target, the preset value of the output signal on the amplifier is set according to the different signal numbers taken by the label on the label roll and the backing paper of the automatic desktop labeling machine. desktop labeling machine：https://ww w.beiltmachinery.com /Round-bottle-deskto p-labeling-machine.h tml | |
1 / 1